Are your garage doors malfunctioning? If your garage door ceases working as efficiently as it did in the past it is likely to be experiencing problems. The sensors, situated on both sides that of your garage door, have an important part in the garage’s operation. The two components of the door, the transmitter (sends signals) and the receiver (receives the signals that shut or open the door) and work together to ensure an optimal performance. However, sensors could be damaged in the event that they’re not in alignment. You’re welcome; we’ll be discussing ways you can align your garage door sensor in the following article.
Instructions for How Align Garage Door Sensors
Make sure to grab these tools before you set the sensors in alignment:
- Lever
- String
- Screwdriver
- Electricity-resistant gloves
It is vital for garage door sensor to be aligned in order to function properly and here’s the best way to do it:
1. Connect the Power Supply to the Outlet.
Since this step requires working with wires, wear your electricity-resistant gloves to stay safe. When your gloves are in place take off the power supply to the garage door’s sensors by shutting off the switch. Additionally, you can utilize the breaker box in your home to turn off the fuse on garage doors.
2. Remove the screws holding the Sensors
Now comes the actual work. It’s time loosen the screws on the brackets for mounting that support the sensors. After that, you’ll have to rotate them in an clockwise until the screws are loose enough to allow them to move freely. Be aware that getting rid of the brackets completely isn’t recommended because you’ll need to slide them down and up again later on. If you feel difficultes and you want to hire a professional Gate Installation Hialeah or gate repair experts.
3. Slide the Sensor downward
You’ll be able to move the bracket upwards and downwards once the screws have been loosen. So, you can use only your hands to move it down. Continue to slide it down as low as you need to while making sure the sensor is in the bracket that holds it. If you are using an instrument, it can create scratches to the sensor and disrupt the function of the sensor.
4. Connect your String & Tie the Knots
The next step is the most important step in the process of aligning the garage door sensors. Before starting, examine the sensors to ensure that they’re at the right position and the correct height. After that, you’ll need to tie every end around the sensors as well as their mounting brackets. The success of the process is dependent entirely on this task. So, the string should appear as straight as it can.
5. Make sure the string is level
Place your level on the floor and set it on the string. Check to see that it is running level through the entrance. Place your level on the string and hold it for couple of minutes. When the string appears to be level it is possible to continue to your next move. If not, continue to adjust until you see how the sensors have been aligned.
6. Make sure you tighten the Screws
If both levels are aligned perfectly according to the leveler you have installed then you can begin tightening the screws. It is important to tighten them to the point that the door’s sensor won’t move when you press it. After that, you should check the leveler to determine whether the sensors are in alignment.
7. Test the Sensors
Then switch the power off and check the sensors to determine whether they are operating well. If they aren’t working, or you’re experiencing other problems, you should contact Gate Operator Repair Hialeah expert.
